19 / 30
4. Now you may move the speed fader to select your desired speed.
Note: The step 3 is not necessary if the selected program is not recorded with the standard beat.
4.3.4. Running a program with a standard beat
1. be sure the „Audio“is disengaged. Tap the “mode Select” button to
select „CHNS<>SCENE” mode.
2Tap the „Park” button to select „Mix Chase” mode, the LED lights
indicating this selection.
3. Select you program as described above.
4. Move the speed fader until the display reads your desired value.
You may tap the “Tap Sync2 button twice to define your beat.
5. While pressing and holding down the „Rec Speed“ button, tap the
„Flash“ button (25-48) that stores the program.
6. The program will then run with the set time or beat when engaged.
7Repeat steps 4 and 5 to set a new beat time.
4.3.5. Change the speed mode between 5 minutes and 10 minutes
1. Press and hold the „Record” button.
To Next Page
Loading...
Need help?
General