18 / 30
4. Move the desired channel fader (25-48) to its maximum position to
trigger the program, and the program will fade in depending upon
current fade time.
You may press and hold down the relevant “Flash” button (25-48) to
trigger the program.
5. Move the channel fader to adjust the output of the current program.
4.3.2. Running a program to audio
1. Use the built-in microphone or plug the audio source into the RCA
audio jack.
2. Select your program as describes above.
3. Tap the „Audio” button until its LED lights, indicating „Audio” mode is
active.
4. Use the audio level fader to adjust the music sensitivity.
5. To return to normal mode, tap the „audio“ button a second time
causing its LED goes out, the „audio“ mode is disengaged.
4.3.3. Running a program with the speed fader
1. be sure the „Audio” mode is disengaged, that is, the „audio“LEDs
goes out.
2. Select your program as described above.
3. Move the speed fader to the SHOW MODE position (the bottom),
then tap the „Flash“ button (13-24) while pressing and holding down
the „Rec Speed“ button, the corresponding program will not run with
standard beat any longer.
To Next Page
Loading...
Need help?
General