28 / 30
6.10. „Add“and „Kill“
The „ADD/KILL“button changes the mode of the „Flash“buttons. Normally the „flash“ buttons are in
„add“ mode., whereas pressing any flash button will not kill other scenes, allowing multiple scenes to
be on at a time.
The “Kill” mode is activated by pressing “ADD/KILL” button and illuminating the LED above it. Pressing
any “Flash” button will kill other active scene or program.
In “Kill” mode, the killed program is not stop running but cannot output.
6.11. Double Preset
1. Press „Mode Select“button to enter „A Double Preset“mode.
2. In this mode, channel faders 1-24 and channel fader 25-48 both control channel 1-24.
3. Master control channels faders 1-24 while master B controls channels faders 25-48.
4. In this mode, no scene could be recorded.
6.12. Example
1. Enter the „Double Preset” mode.
2. Push channels fader 1 to 6 to the top and move channel faders 19 to 24 to the maximum.
3. Move master A and B to the same level and push them to the same direction, you will get a scene.
To Next Page
Loading...
Need help?
General