27 / 30
6.5. „Single“mode
1. All programs will run in sequential order starting in the order of program number.
2. The display will read the running program number.
3. All programs will be controlled by the same speed fader.
4. Press the „Mode Select“button and select „CHNS<>SCENES“.
5. Press the „Park“button to select „Single Chase“mode. A red LED will indicate this selection.
6.6. „Mix“mode
1. Will run all programs synchronously.
2. All programs can be controlled by the same speed fader, or each programs speed may controlled
individually. (Ch. 3.3.3)
3. Press the „Mode Select“button and select „CHNS<>SCENES“.
4. Press the „Park“button to select „Mix Chase“mode. A yellow LED will indicate this selection.
6.7. Dimmer Display
1. The display is used to display intensity percentage or absolute DMX value. .
2. To change between percentage and absolute value:
Press and hold the “Shift” button. While holding down the “Shift” button press the “% or 0-255” button
to switch between percentage and absolute values.
6.8. „Blind“and „Home“
1. Blind function takes channels temporally out from a chase, when the chase is running, and gives
you manual control over the channel.
2 .Press and hold the „Blind“ button and tap the relative „Flash“ button you want to temporarily take
out of the chase.
3. To return to normal chase gain press and hold the „Home“ button and push the “Flash” button you
want to return to normal chase.
6.9. Park
1. In „CHNS<>SCENES“mode, press down the button you can change the chasing mode of programs
between „Single“mode and „Mix“mode.
2. In „Double Preset” mode, pressing down this button is equal to pushing master fader B to the top.
3. In „Single Preset” mode, this button could temporally record current output, with master fader B to
adjust.
To Next Page
Loading...
Need help?
General