7 / 30
11. UP/CHASE REV
“Up” is used to modify a scene in “Edit” mode.
“Chase Rev” is to reverse the chasing direction of a scene under speed fader control.
12. PAGE button
Tap to select pages of scenes from Page 1-4.
13. DELETE/REV ONE
Delete any step of a scene or reverse the chasing direction of any program.
14. Display
The display shows the current activity or programming state.
15. INSERT/% OR 255
„Insert” is to add one step or steps into a scene.
“% or 0-255” is used to change display value cycle between % and 0-255.
16. EDIT/ALL REV
„Edit” is used to activate „Edit” mode.
“All Rev” is to reverse the chasing direction of all programs.
17. ADD OR KILL/REC EXIT
In „Add” mode, multiple scenes or „Flash“buttons will be on at a time.
In “Kill” mode, pressing any “Flash” button will kill any other scenes or programs.
“Rec Exit” is used to exit from “Program” or “Edit” mode.
18. RECORD/SHIFT
„Record” is used to activate „Record” mode or program a step.
“Shift” functions only used with other buttons.
19. MASTER A button
This button brings channel 1-24 to full of current setting.
20. PARK button
Used to select „Single/Mix Chase“, bring channel 25-48 to full of current setting, or momentarily
program a scene into „Master B“ fader, depending on the current mode.
21. HOLD button
This button is used to maintain current scene.
22. STEP button
This button is used to go to next step when the „Speed“ fader is pushed to the bottom or in „Edit“
mode.
23. AUDIO button
This button activates audio sync of chase and audio intensity effects.
24. MASTER A Fader
This fader controls overall output of all channels.
25. MASTER B Fader
This fader controls the chase of all programs.
26. BLIND button
This function takes the channel out of the chase of a program in „CHNS<>SCENE“mode.
To Next Page
Loading...
Need help?
General