5.1
NOTICE
Problem Possible Causes Corrective Action
Starter does not turn the
engine over.
• Auxiliary hydraulics lever is
either in Forward or Reverse
position with no hydraulically
powered attachment installed.
• Move lever to neutral
position.
• Battery is dead. • Charge the battery.
• If battery does not hold a
charge, replace the battery.
• Electrical connections are
corroded or loose.
• Check electrical connections
for good contact.
• Remove cables from battery
terminals and fully clean
battery terminals and cable
clamps.
• If the cable clamps can not
be properly cleaned, replace
connectors.
• Relay or starter switch is
defective.
• Contact Authorized Service
Dealer.
• Engine is in hydraulic lock due
to a cylinder lled with fuel.
• Allow engine to cool before
attempting this procedure.
• Remove fuel injectors and
turn engine over to pump
excess fuel from engine
cylinder.
Section 5 - Troubleshooting
The following procedures will assist you in determining the potential cause of a machine
operating problem.
Make sure to follow all safety precautions stated in this manual when
doing any work on the machine.
To Next Page
Loading...
