BOXER 700HDX - Fuse Panel

Routine Service and Maintenance
4.24
11. Fill the fuel tanks with fresh diesel fuel.
NOTE: Place a container underneath the fuel injection pump to catch any spilled
diesel fuel. Dispose of the used fuel in an appropriate manner.
12. Loosen the air bleed screw on the top of the lter assembly slightly. DO NOT
remove this bolt.
13. Loosen the air bleed bolt (Item 2, Figure 4–24). DO NOT remove this bolt.
14. Raise and lower the primer pump handle (Item 1, Figure 4–24) until only diesel
fuel without any air bubbles comes out of the air bleed.
15. Fully tighten the air bleed bolt.
Make sure to clean up any spilled fuel from in and around the engine compartment of
the machine. Spilled fuel may be ignited by a hot engine.
Fuse Panel
The electrical circuits on the machine are protected by fuses. The fuse panel is located below
the gauge indicator panel, underneath the removable locking access panel.
If a fuse blows, determine the cause before replacing it with a new one.
Always replace fuses with ones matching the amperage rating shown on the top of the
blown fuse.
CAUTION
NOTICE
CAUTION