100-214-239 Rev. A 6-35
Remote Computer or Terminal
Digital Sonifier
Table 6-3: Remote Terminal Commands
Command Terminal Displays User / System Action
!T TIME=
Type a value for the time, and press Enter on your
remote computer or terminal.
!MT MAX TEMP=
Type the maximum temperature, and press Enter on
your remote computer or terminal.
!PO PULSE ON=
Type the time period when power will be on, and press
Enter on your remote computer or terminal.
!POF PULSE OFF=
Type the time period when power will be off, and press
Enter on your remote computer or terminal.
!PPT PULSE TEMP=
Type the Pulse Temperature, and press Enter on your
remote computer or terminal.
!SV PRESET ID#
Type the identifying number under which you want to
save the preset parameter values, and press Enter on
your remote computer or terminal.
!R PRESET ID#
Type the preset ID number for the saved set of param-
eters you want to use, and press Enter on your remote
computer or terminal.
!RP List of parameters
The system displays all the current parameters on the
remote computer or terminal.
!S Report
The system sends a report to the remote computer or
terminal.
!P N/A The system sends a report to the printer.
!H EXPERIMENT PAUSED
The experiment is currently paused.
Issuing another pause command from the remote
terminal will cause the experiment to resume, if the
experiment is currently paused.
!TS
TUNING TEST
PLEASE WAIT 2 SEC.
Ultrasonics are activated for a two-second test.
!KL * KEYPAD DISABLED *
The keypad is disabled, or enabled if it was already dis-
abled.
!ON
EXPERIMENT RUNNING
(displayed every 5 seconds)
The experiment is running from a remote command.
!OFF EXPERIMENT STOPPED The experiment has been stopped.
To Next Page
Loading...
