6.2 Commissioning
1. Connect the pipework.
CAUTION
Make sure that there are no obstructions such as closed valves.
2. Connect the pump to the electrical supply.
3. Switch on the electrical supply.
4. Check the rotation of the rotor.
5. Make sure that the hose clamps are fitted properly.
6. Check the capacity of the hose pump. If the capacity differs from your specification, follow the
instructions in Troubleshooting or contact your Bredel representative for advice.
7. If a frequency controller is present, check the capacity range. In case of any deviations consult
the supplier’s documentation.
8. Check the hose pump in accordance with points 2 to 4 of the maintenance table.
See also
Refer to "Maintenance and periodic inspections" on page 41
Refer to "Tightening the hose clamps" on page 54 for how to tighten the hose clamps
Refer to "Troubleshooting" on page 76
34 m-bredel-25-32-en-05
To Next Page
Loading...
