EasyManuals Logo

Brocade Communications Systems FCX Series User Manual

Brocade Communications Systems FCX Series
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
Modified CLI examples for the 2-port 10 Gbps SFP+ module
The following sample output from the show module command displays an entry
for the 2-port 10G SFP+ module.
device# show module
Module
Status Ports Starting MAC
U1:M1 FCX-48GS POE 48-port Management Module
OK 48 0024.38c9.4d00
U1:M2 FCX-2XGC 2-port 16G Module (2-CX4)
OK 2 0024.38c9.4d31
U1:M3 FCX-2SFPP 2-port 10G Module (2-SFP+)
OK 2 0024.38c9.4d33
The following sample output from the show version command shows that the 2-
port 10G SFP+ module is in slot 3.
device# show version
Copyright (c) 1996-2011 Brocade Communications Systems,
Inc.
UNIT 1: compiled on Oct 18 2012 at 16:01:04 labeled as
FCXS07300b1
(5373912 bytes) from Primary
FCXS07300b1.bin
SW: Version 07.3.00b1T7f1
Boot-Monitor Image size = 370663, Version:07.3.00T7f5
(grz07300b1)
HW: Stackable FCX648S-HPOE-PREM (PROM-TYPE FCX-ADV-U)
===========================================================
===============
UNIT 1: SL 1: FCX-48GS POE 48-port Management Module
Serial #: BCYXXXXXXXX
License: BASE_SOFT_PACKAGE (LID: deaHHJIhFNb)
P-ENGINE 0: type DB90, rev 01
P-ENGINE 1: type DB90, rev 01
PROM-TYPE: FCX-ADV-U
===========================================================
===============
UNIT 1: SL 2: FCX-2XGC 2-port 16G Module (2-CX4)
===========================================================
===============
UNIT 1: SL 3: FCX-2SFPP 2-port 10G Module (2-SFP+)
===========================================================
===============
800 MHz Power PC processor 8544E (version 0021/0022) 400
MHz bus
65536 KB flash memory
256 MB DRAM
STACKID 1 system uptime is 2 days 10 minutes 24 seconds
The system : started=warm start reloaded=by "reload"
The following is sample output of the show running-config command.
device# show running-config
!
Startup-config data location is flash memory
!
Startup configuration:
!
ver 07.3.00a001T7f1
!
stack unit 1
module 1 fcx-48-poe-port-management-module
module 2 fcx-cx4-2-port-16g-module
module 3 fcx-sfpp-2-port-10g-module
!
Installing the FCX Switch
Brocade FCX Series Hardware Installation Guide 57
53-1002977-01

Table of Contents

Other manuals for Brocade Communications Systems FCX Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems FCX Series and is the answer not in the manual?

Brocade Communications Systems FCX Series Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelFCX Series
CategorySwitch
LanguageEnglish

Related product manuals