Brocade Communications Systems FCX Series User Manual

Installing a transceiver
You can install a new transceiver in an XFP, SFP, or SFP+ slot while the device is powered on and
running.
While installing a transceiver, wear an ESD wrist strap with a plug for connection to a metal surface.
NOTE
For safety reasons, the ESD wrist strap should contain a series 1 meg ohm resistor.
CAUTION
All fiber optic interfaces use Class 1 lasers.
Use the following setps to install a transceiver.
Installing a transceiver
68 Brocade FCX Series Hardware Installation Guide
53-1002977-01

Brocade Communications Systems FCX Series Specifications

General

Brand	Brocade Communications Systems
Model	FCX Series
Category	Switch
Language	English