3-14
Brooks
®
Digital MFC's & MFM's
Section 3 Operation
Installation and Operation Manual
X-TMF-SLA5800-MFC-eng
Part Number: 541B027AAG
April, 2013
3-8-8 Flow Signal Lock-in
When this feature is enabled, the Flow Out signal will “lock-in” to the
setpoint value whenever the error between measured Flow and Setpoint is
less than a configurable value.
3-9 PC-based Support Tools
Brooks Instrument offers a variety of PC-based process control and service
tools to meet the needs of our customers. SmartDDE may be used with any
unit supporting RS-485 in a multidrop configuration, thus allowing users to
control and monitor their Brooks devices. The Brooks Service Suite (Analog
I/O versions only) may be used to monitor, diagnose, tune and calibrate
Brooks devices. The Brooks Service Suite interfaces with Brooks products
via a special service port. The Brooks Service Tool (BST) may be used for
devices equipped with digital communications to perform many of the same
tasks as the Brooks Service Suite.
To Next Page
Loading...
