Models 5800-S
Installation and Operation Manual
X-TMF-5800S-MFC-eng
PN 541-C-051-AAG
November, 2008
9
Section 2: Installation
2.1 General
This section contains the procedures for the receipt and installation of the
instrument. Do not attempt to start the system until the instrument has been
permanently installed. It is extremely important that the start-up procedures be
followed in the exact sequence presented.
NOTE: Operating procedure: do not operate this instrument outside the
specification range listed in section 5.
Before bringing the unit into operation, make sure that all gas connections have
been correctly tightened and that all the necessary electrical connections have
been made.
2.2 Receipt of Equipment
When the equipment is received, the outside packing case should be checked
for damage incurred during shipment. If the packing case is damaged, the local
carrier should be notified at once regarding his liability. A report should be
submitted to your nearest Product Service Department.
Brooks Instrument
407 W. Vine Street
P.O. Box 903
Hatfield, PA 19440 USA
Toll Free (888) 554-FLOW (3569)
Tel (215) 362-3700
Fax (215) 362-3745
Email: BrooksAm@BrooksInstrument.com
http://www.brooksinstrument.com
Brooks Instrument Brooks Instrument
Neonstraat 3 1-4-4 Kitasuna Koto-Ku
6718 WX Ede, Netherlands Tokyo, 136-0073 Japan
P.O. Box 428 Tel 011-81-3-5633-7100
6710 BK Ede, Netherlands Fax 011-81-3-5633-7101
Tel 31-318-549-300 Email: BrooksAs@BrooksInstrument.com
Fax 31-318-549-309
Email:BrooksEu@BrooksInstrument.com
Remove the envelope containing the packing list. Carefully remove the
instrument from the packing case. Make sure spare parts are not discarded with
the packing materials. Inspect for damaged or missing parts.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
