General Setup
25
3
Sleep Time 3
The Sleep Time setting can reduce power
consumption by turning off the fuser while the
machine is idle.
You can choose how long the machine must
be idle before it goes into sleep mode. When
the machine receives computer data or
makes a copy, the timer will be reset. The
default setting is 005 minutes.
While the machine is in sleep mode the LCD
will display Sleep. When printing or copying
in sleep mode, there will be a short delay
while the fuser warms up.
a Press Menu 1, 3, 2.
13.Ecology
2.Sleep Time
005Min
Enter & OK Key
b Enter the length of time the machine is
idle before entering sleep mode.
Press OK.
c Press Stop/Exit.
Note
To turn off sleep mode, press
Secure/Direct and Job Cancel at the
same time in step b. Press a or b to
choose Off. Press OK.
Turning off the scanner
lamp 3
The scanner lamp stays on for 16 hours
before automatically switching off to preserve
the life of the lamp and reduce power
consumption.
To turn the scanner lamp off manually press
the d and c keys simultaneously. The scanner
lamp will remain turned off until the next time
you use the scanning feature.
Note
Turning the lamp off regularly will reduce
the lamp’s life.
LCD Contrast 3
You can change the contrast to make the
LCD look lighter or darker.
a Press Menu, 1, 5.
15.LCD Contrast
-nnonn+
Select dc&OK
b Press d to make the LCD lighter. Or,
press c to make the LCD darker.
Press OK.
c Press Stop/Exit.
To Next Page
Loading...
Need help?
General
