Brother 8085DN - DCP B/W Laser User Guide

Chapter 5
40
Tray selection 5
You can change the Tray Use only for the
next copy.
a Load your document.
b Use the dial pad to enter the number of
copies (up to 99).
c Press Tray Select.
d Press d or c to choose the MP>T1,
T1>MP, #1(XXX)
1
or MP(XXX)
1
.
Press OK.
e Press Start.
1
XXX is the paper size you set in Menu, 1, 1, 2.
Note
• T2 or #2 appears only if the optional paper
tray is installed.
• To change the default setting for Tray
Select, see Tray Use in copy mode
on page 23.
Out of memory
message 5
If the memory becomes full while you are
making copies, the LCD message will guide
you through the next step.
If you get an Out of Memory message
while scanning a subsequent page, you will
have the option to press Start to copy the
pages scanned so far, or to press Stop/Exit
to cancel the operation.
Press MP>T1 or M>T1>T2
T1>MP or T1>T2>M
#1(XXX)
1
#2(XXX)
1
MP(XXX)
1

Brother 8085DN - DCP B/W Laser Specifications

General

Printer Type	Laser
Functions	Print, Copy, Scan
Duplex Printing	Yes
Copy Resolution	Up to 600 x 600 dpi
Scanner Type	Flatbed, ADF
Memory	32 MB
Operating System Compatibility	Windows, Mac, Linux
Scan Resolution	Up to 19200 x 19200 dpi (interpolated)
Paper Capacity	250 sheets
Connectivity	Ethernet