Making copies
27
4
If you have finished choosing settings, press
Mono Start or Colour Start.
If you want to choose more settings, press a
or b.
Note
You can save some of the settings that
you use most often by setting them as
default. These settings will stay until you
change them again. (See Setting your
changes as a new default on page 32.)
Changing copy speed and
quality 4
You can choose the copy quality. The factory
setting is Normal.
a Load your document.
b Enter the number of copies you want.
c Press a or b to choose Quality.
d Press d or c to choose Fast, Normal or
Best.
Press OK.
e If you do not want to change additional
settings, press Mono Start or
Colour Start.
Enlarging or reducing the
image copied 4
You can choose an enlargement or reduction
ratio.If you choose Fit to Page, your
machine will adjust the size automatically to
the paper size you set.
a Load your document.
b Enter the number of copies you want.
c Press a or b to choose
Enlarge/Reduce.
d Press d or c to choose Enlarge ,
Reduce, Fit to Page ,
Custom(25-400%), or 100%.
e Do one of the following.
If you choose Enlarge or Reduce
press OK and press d or c to choose
the enlargement or reduction ratio
you want. Press OK and go to
step f.
If you choose Custom(25-400%),
press OK. Press + or - to enter an
enlargement or reduction ratio from
25% to 400%. Press OK. Go to
step f.
If you choose 100% or
Fit to Page, press OK. Go to
step f.
Fast Fast copy speed and lowest
amount of ink used. Use this
setting to save time (documents to
be proof read, large documents or
many copies).
Normal Recommended setting for ordinary
print outs. Good copy quality with
adequate copy speed.
Best Use this setting to copy precise
images such as photographs. The
highest resolution and slowest
speed.
198% 10x15 cmiA4
186% 10x15 cmiLTR
142% A5iA4
97% LTRiA4
93% A4iLTR
83%
69% A4iA5
47% A4i10x15cm
Fit to Pag e
Custom(25-400%)
100%
To Next Page
Loading...
Need help?
General
