Printing photos from a memory card or USB Flash memory drive
41
5
Remove Red-Eye 5
The machine detects eyes in your photos and
will attempt to remove red-eye from your
photo.
Note
There are some cases when red-eye may
not be removed.
•
When the face is too small in the image.
• When the face is turning too far up,
down, left or right.
a Make sure you have put a memory card
or USB Flash memory drive in the
correct slot.
Press (Photo Capture).
b Press a or b to choose
Enhance Photos .
Press OK.
c Press d or c to choose your photo.
Press OK.
d Press a or b to choose
Remove Red-Eye .
Press OK.
When Remove Red-Eye is
successful, the photo with the effect
is shown. The adjusted part is shown
in a red frame. Press OK.
When Remove Red-Eye is
unsuccessful,
Unable to Detect. is shown.
Press OK to go back to the previous
level.
Note
Press a to try Remove Red-Eye again.
e Press + or - repeatedly to enter the
number of copies you want.
f Do one of the following.
Press OK and change the print
settings. (See page 45.)
If you do not want to change any
settings, press Colour Start to print.
Monochrome 5
You can convert your photo to monochrome.
a Make sure you have put a memory card
or USB Flash memory drive in the
correct slot.
Press (Photo Capture).
b Press a or b to choose
Enhance Photos .
Press OK.
c Press d or c to choose your photo.
Press OK.
d Press a or b to choose Monochrome.
Press OK.
e Press OK. Then press + or - repeatedly
to enter the number of copies you want.
f Do one of the following.
Press OK and change the print
settings. (See page 45.)
If you do not want to change any
settings, press Colour Start to print.
To Next Page
Loading...
Need help?
General
