Brother DCP-7010L - Scanning an Image into Your Macintosh

Using your machine with a Macintosh
®
7 - 14
7
Scanning an image into your Macintosh
®
You can scan a whole page.
—OR—
scan a portion after pre-scanning the document.
Scanning a whole page
1 Load your document in the ADF.
Note
If your model is a flatbed type, you can also place your document on the scanner glass.
2 Adjust the following settings, if needed, in the Scanner Setup dialog box:
Resolution
Colour Type
Scanning Area
Brightness
Contrast
3 Click Start.
When scanning has finished, the image will appear in your graphics application.