Brother DCP 8060 - 4 Network Scanning (for Models with Built-In Network Support); Before Using Network Scanning; Configuring Network Scanning

75
4
To use the machine as a network scanner, the machine must be configured with a TCP/IP address. You can
set or change the address settings from the control panel (See the Network User’s Guide on the CD-ROM).
If you installed the machine following the instructions for a network user in the Quick Setup Guide then the
machine should already be configured for your network.
Before using Network Scanning 4
Configuring Network Scanning 4
If you need to change the machine that was registered to your PC during the installation of MFL-Pro Suite
(see the Quick Setup Guide), follow the steps below.
a For Windows
®
XP, click the Start button, Control Panel, Printers and Other Hardware, then
Scanners and Cameras (or Control Panel, Scanners and Cameras).
For Windows
®
98/Me/2000, click the Start button, Control Panel, then Scanners and Cameras.
b Right-click the Scanner Device icon and choose Properties.
The Network Scanner Properties dialog box appears.
Network Scanning (For models with
built-in network support)
4