Brother GTX-4 - Page 298

298
Troubleshooting
Error code Error message Description Remedy
4500 [Machine Error]
The network interface was
unable to be activated.
Press
to clear the error.
Contact your network setup manager and network
administrator.
If the problem still persists, please contact your
dealer.
4501 [IP Address Setting Error]
An error has been detected in
the static IP address setting
and subnet mask value.
Press
to clear the error.
Use the maintenance tool to set up a correct static
IP address and subnet mask value once again.
4502 [Machine Error]
The network interface setting
has ended up in failure.
Press
to clear the error.
Contact your network setup manager and network
administrator.
If the problem still persists, please contact your
dealer.
4503 [Machine Error]
An error was found in the
static IP address of the
default gateway.
Press
to clear the error.
Use the maintenance tool to set up a correct static
IP address of default gateway once again.
4504 [IP Address Setting Error]
It is the error of static IP
address setup value.
Press
to clear the error.
Use the maintenance tool to set up a correct static
IP address and subnet mask value once again.
4506 [No Enable Restore Data]
No data can be restored
because its backup copy was
not made.
Make note of the error code and error message,
and please notify it to your dealer.
5001 [Machine Error]
A timeout has occurred at the
time of initialization.
Make note of the error code and error message,
and please notify it to your dealer.
5010 [PC Data Error]
An error is detected in the
current print data being run.
Press
to clear the error.
Create the print data again on the PC to load it to
the printer, and try the print operation again.
5020 [Machine Error]
The carriage movement was
not completed.
If the problem still persists even after restarting the
printer, please contact your dealer.
5021 [Machine Error] Head operation is incomplete.
If the problem still persists even after restarting the
printer, please contact your dealer.
5022 [Machine Error] Head operation is incomplete.
If the problem still persists even after restarting the
printer, please contact your dealer.
5080 [Machine Error]
Maintenance unit operation is
incomplete.
If the problem still persists even after restarting the
printer, please contact your dealer.
5081 [Machine Error]
Maintenance unit operation is
incomplete.
If the problem still persists even after restarting the
printer, please contact your dealer.
5094 [Machine Error]
The platen cannot be moved
toward the rear of the printer.
Make note of the error code and error message,
and please notify it to your dealer.
5095 [Machine Error]
The platen cannot be moved
toward the front of the printer.
Make note of the error code and error message,
and please notify it to your dealer.