Brother HL-2170W - Protocol-specific troubleshooting

3-61
Confidential
(2) Remove the Taptite cup S M3x6 SR screw and the nine Taptite bind B M4x12 screws,
and then remove the Drive sub ASSY from the Main body.
Fig. 3-56
CAUTION:
When removing the Drive sub ASSY, put the left side of the Main body as the top as shown in
the above figure because there is risk of the fall of the gears.
Taptite bind B M4x12
Taptite bind B M4x12
Taptite bind B M4x12
Taptite cup S M3x6 SR
Taptite bind B M4x12
Drive sub ASSY