4-9
Confidential
■ Inputting the adjusted value of the laser scanner
<Procedures>
(1) Double-click the brmainte. EXE file (maintenance utility) to start.
Select “Input Information” from Menu. Select the applicable model name.
(2) Select “Adjust Scanner” from Menu.
(3) Check the port (USB) that the machine is connected through.
(4) Enter the figures (the last four digits) shown on the label attached on the chassis at the
right hand side of the main PCB into the box at the right hand side.
(5) Click the OK button.
To Next Page
Loading...
