2-40
Confidential
Tray 2 Error
Take out Tray 2 and
push it back in
firmly.
After the T2 paper tray unit is
opened and closed or the power
is turned ON, the T2 plate origin
sensor detects that lift-up of the
plate of the T2 paper tray unit is
not completed within the
specified period of time.
6C02 2-60
Tray 3 Error
Take out Tray 3 and
push it back in
firmly.
After the T3 paper tray unit is
opened and closed or the power
is turned ON, the T3 plate origin
sensor detects that lift-up of the
plate of the T3 paper tray unit is
not completed within the
specified period of time.
6C03 2-61
Unable to
Update
Press Stop[x].Wait
until Ready state
and try again.
Execution of the program update
cannot be started because other
function is being executed.
--- 4.11.3
Unusable
Device
Unusable Device
An USB device that did not meet
the specifications was inserted
into the USB port.
--- 4.11.2
Remove the
Device. Turn the
power off and back
on again.
Overcurrent was caused
because a USB device that did
not meet the specifications was
inserted into the USB port.
EC00 2-83
2-sided
Disabled
-
The back cover sensor detected
the open state when
2-sided printing is started.
(before the registration of printing
in the engine)
8903 2-69
The back cover sensor detected
the open state during 2-sided
printing. (after the registration of
printing in the engine)
8904 2-69
Reload paper,
then press [Retry].
The registration rear sensor
detected that the length of the
paper is too long and it may hit
within the machine in 2-sided
printing.
8A02 2-69
Error Message
State
Error
Codes
Refer
to:
Upper line Middle line
To Next Page
Loading...
