Brother MFC-250C - Page 225

Network Scanning (For models with built-in network support)
217
12
Factory reset 12
You can reset Quality, File Type, Glass ScanSize and File Name to the factory settings.
a Press the (Scan) key.
b Press a or b to choose Scan to FTP.
Press OK.
c Press a or b to choose Manual.
Press OK.
Note
If there is no FTP Profile configured, skip c and go to d.
d Enter the FTP host address (for example ftp.example.com up to 60 characters) or the IP address (for
example 192.23.56.189).
Press OK.
e Enter the destination folder (for example /brother/abc/, up to 60 characters).
Press OK.
f Enter Username. Press OK.
g Enter Password. Press OK.
h Press a or b to choose Factory Reset.
Press OK.
i Press 1 to choose Yes.
j Press Stop/Exit.