Brother MFC-8710DW - Setting the Password for the Administrator; Changing the Password for the Administrator

Chapter 2
8
Setting the password for the
administrator 2
The password you set in these steps is for the
administrator. This password is used to set
up users and to turn the Secure Function
Lock on or off. (See Setting up restricted
users uu page 9 and Turning Secure
Function Lock on/off uu page 10.)
a Press Menu, 1, 8, 1.
18.Security
1.Function Lock
New Passwd:XXXX
Enter & OK Key
b Enter a four-digit number for the
password using numbers 0-9.
Press OK.
c Re-enter the password when the LCD
shows Verify:.
Press OK.
d Press Stop/Exit.
Changing the password for
the administrator 2
a Press Menu, 1, 8, 1.
18.Security
1.Function Lock
a Lock OffiOn
b Set Password
Select ab or OK
b Press a or b to choose Set Password.
Press OK.
c Enter the registered four-digit password.
Press OK.
d Enter a four-digit number for the new
password.
Press OK.
e If the LCD shows Verify: re-enter the
new password.
Press OK.
f Press Stop/Exit.