Brother MFC-9140CDN - Page 50

Chapter 4
42
Delayed polling 4
Delayed polling lets you set the machine to
begin polling receive at a later time. You can
only set up one delayed polling operation.
a Do one of the following:
 When Fax Preview is set to Off,
press (Fax).
 When Fax Preview is set to On, press
(Fax) and Sending Faxes.
b Press Options.
c Swipe up or down, or press a or b to
display Polling RX.
d Press Polling RX.
e Press Timer.
f Enter the time (in 24-hour format) you
want to begin polling.
Press OK.
g Enter the fax number you are polling
using Address Book or the dial pad on
the Touchpanel.
h Press Fax Start.
NOTE
If the other fax machine that you are
calling has not been set-up for Polling, you
will receive the message
Connection Failed.
Sequential polling 4
Sequential polling lets you request
documents from several fax machines in one
operation.
a Do one of the following:
 When Fax Preview is set to Off,
press (Fax).
 When Fax Preview is set to On, press
(Fax) and Sending Faxes.
b Press Options.
c Swipe up or down, or press a or b to
display Polling RX.
d Press Polling RX.
e Press Standard, Secure or Timer.
f Choose one of the options below.
 If you chose Standard, go to
step g.
 If you chose Secure, enter a
four-digit number, press OK. Go to
step g.
 If you chose Timer, enter the time
you want to begin polling (in
24-hours format) and press OK. Go to
step g.
NOTE
If you did not enter the correct Secure
Code, you will receive the massage
Disconnected.
g Press Options.
h Swipe up or down, or press a or b to
display Broadcasting.
i Press Broadcasting.
j Press Add Number.