Setting Up the Machine
6
STEP 1
2 While pressing the green paper-guide release
lever (1), slide the paper guides to fit the paper
size. Make sure that the guides are firmly in the
slots.
3 Fan the stack of paper well to avoid paper jams
and misfeeds.
4 Put paper in the paper tray. Make sure that the
paper is flat in the tray and below the maximum
paper mark.
5 Put the paper tray firmly back into the machine.
4 Release the Scanner Lock
1 Push the lever (1) in the direction to unlock the
scanner.
(The gray scanner lock lever is located at the
back left side, under the docment cover (2) )
5 Install the power cord and
phone line
1 Make sure that the machine power switch is off.
Remove the label covering the AC power inlet.
2 Connect the AC power cord to the machine.
3 Plug the AC power cord into an AC outlet. Turn
the power switch on.
(1)
(1)
(2)
To Next Page
Loading...
