94
(MFC-J2310 and
MFC-J4410DW)
No Paper Fed
(MFC-J4610DW)
No Paper Fed
No Paper Fed #1
No Paper Fed #2
The machine is out of paper or the
paper is not correctly loaded in the
paper tray.
Do one of the following:
Refill the paper in the paper tray,
and then press OK on the
Touchscreen.
Remove the paper and load it
again, and then press OK on the
Touchscreen. (See Loading paper
and other print media on page 15.)
The paper is jammed in the machine. Remove the jammed paper by
following the steps in Printer jam or
paper jam on page 101.
If this error occurs often during 2-sided
copying or 2-sided printing, the paper
feed rollers may be stained with ink.
Clean the paper feed rollers.
(See Advanced User’s Guide:
Cleaning the paper feed rollers.)
Paper dust has accumulated on the
surface of the paper pick-up rollers.
Clean the paper pick-up rollers.
(See Advanced User’s Guide:
Cleaning the paper pick-up rollers.)
The Jam Clear Cover is not closed
correctly.
Make sure the Jam Clear Cover is
closed evenly at both ends. (See
Printer jam or paper jam
on page 101.)
The paper was not inserted in the
centre position of the manual feed slot.
Remove the paper and re-insert it in
the centre of the manual feed slot, and
then press OK on the Touchscreen.
(See Loading paper in the manual
feed slot on page 24.)
No Response/Busy The number you dialled has not
answered or is busy.
Verify the number and try again.
Not Registered You tried to access a Speed Dial
number that has not been set up in the
machine.
Set up the Speed Dial number. (See
Storing Speed Dial numbers
on page 61.)
Out of Fax Memory The fax memory is full. Do one of the following:
Clear the data in the memory. To
gain extra memory, you can turn
off Memory Receive.
(See Advanced User’s Guide:
Turning off Memory Receive
operations.)
Print the faxes that are in the
memory. (See Advanced User’s
Guide: Printing a fax from the
memory.)
Error Message Cause Action
To Next Page
Loading...
Need help?
General
