15
2
2
Loading paper and
other print media
2
DO NOT carry the machine by holding the
scanner cover, the Jam Clear Cover, the
manual feed slot cover, or the control panel.
Doing this may cause the machine to slip
out of your hands. Carry the machine by
sliding your hands into the handhold
indentations located on each side of the
machine.
For detailed information, see Product
Safety Guide.
(For MFC-J4610DW)
For tray #2 (lower tray), see Loading
paper in paper tray #2 (MFC-J4610DW)
on page 21.
Loading paper in paper
tray #1 2
Load only one size of paper and one type of
paper in the paper tray at any time.
a Pull the paper tray completely out of the
machine.
• If the paper support flap (1) is open, close
it, and then slide the paper support (2) into
the output paper tray cover.
• When you load a different paper size in
the tray, you will need to change the paper
size setting in the machine at the same
time.
(MFC-J2310 and MFC-J4410DW: See
Paper Size on page 29.)
(MFC-J4610DW: See Paper Size and
Type (MFC-J4610DW) on page 30.)
b Open the output paper tray cover (1).
Loading paper 2
2
1
1
To Next Page
Loading...
Need help?
General
