Routine maintenance
81
A
e Each colour has its own correct position.
Insert the ink cartridge in the direction of
the arrow on the label.
f Gently push the back of the ink cartridge
marked “PUSH” until the cartridge lever
lifts, and then close the ink cartridge
cover.
g The machine will automatically reset the
ink dot counter.
• If you replaced an ink cartridge, for
example Black, the Touchscreen may ask
you to verify that it was a brand new one
(for example, Did You Change
Black). For each new cartridge you
installed, press Yes to reset the ink dot
counter for that colour. If the ink cartridge
you installed is not a brand new one, be
sure to press No.
• If the Touchscreen shows
No Ink Cartridge or
Cannot Detect after you install the ink
cartridge check that the ink cartridge is a
brand new Brother Original cartridge and
that it is installed correctly. Remove the
ink cartridge and reinstall it slowly until the
cartridge lever lifts.
• DO NOT take out ink cartridges if you do
not need to replace them. If you do so, it
may reduce the ink quantity and the
machine will not know the quantity of ink
left in the cartridge.
•
DO NOT touch the cartridge insertion slots.
If you do so, the ink may stain your skin.
• If ink gets on your skin or clothing
immediately wash it off with soap or
detergent.
• If you mix the colours by installing an ink
cartridge in the wrong position, the
Touchscreen shows
Wrong Ink Colour. Check which ink
cartridges are not matched by colours to
their ink cartridge positions and move
them to their correct positions.
• Once you open an ink cartridge, install it in
the machine and use it up within six
months of installation. Use unopened ink
cartridges by the expiration date written on
the cartridge package.
• DO NOT dismantle or tamper with the ink
cartridge; this can cause the ink to leak out
of the cartridge.
To Next Page
Loading...
Need help?
General
