Level 1 Level 2 Level 3 Level 4 Descriptions
Wired LAN TCP/IP APIPA
- Set the machine to allocate
the IP address from the link-
local address range
automatically.
IPv6
- Turn the IPv6 protocol on or
off. To use the IPv6 protocol,
go to the Brother Solutions
Center at support.brother.com
for more information.
Ethernet
- - Select the Ethernet link mode.
Wired Status
- - View the current wired status.
MAC Address
- - View the machine's MAC
address.
WLAN TCP/IP BOOT Method
- Select the BOOT method that
best suits your needs.
IP Address
- Enter the IP address.
Subnet Mask
- Enter the Subnet mask.
Gateway
- Enter the Gateway address.
Node Name
- Enter the Node name.
WINS
Configuration
- Select the WINS configuration
mode.
WINS Server
- Specify the IP address of the
primary or secondary WINS
server.
DNS Server
- Specify the IP address of the
primary or secondary DNS
server.
APIPA
- Set the machine to allocate
the IP address from the link-
local address range
automatically.
IPv6
- Turn the IPv6 protocol on or
off for a wireless LAN. To use
the IPv6 protocol, go to the
Brother Solutions Center at
support.brother.com for more
information.
Setup Wizard
- - Configure your internal print
server manually.
WLAN
Assistant
- - Configure your wireless
network settings using the
Brother CD-ROM.
WPS
- - Configure your wireless
network settings using the
one-button push method.
WPS w/ PIN
Code
- - Configure your wireless
network settings using WPS
with a PIN.
WLAN Status Status
- View the current wireless
network status.
Signal
- View the current wireless
network signal strength.
766
To Next Page
Loading...
Need help?
General
