Brother MFC-J470DW - Fax Sending Settings

Sending a fax
25
4
e Press Mono Start or Colour Start.
Faxing from the ADF 4
 The machine starts scanning the
document to be sent.
Faxing from the scanner glass 4
 If you pressed Mono Start, the
machine starts scanning the first
page. Go to step f.
 If you pressed Colour Start, the
LCD asks if you want to send a
colour fax. Press 1 to choose
Colour fax to confirm. The
machine starts scanning and
sending the document.
f When the LCD asks you Next Page?,
do one of the following:
 To send a single page, press 2 to
choose No(Send) (or press
Mono Start again).
The machine starts sending the
document.
 To send more than one page, press
1 to choose Yes and go to step g.
g Place the next page on the scanner
glass.
Press OK.
The machine starts scanning the page.
(Repeat steps f and g for each
additional page.)
h After all the pages have been scanned,
press 2 or Mono Start to start sending.
Stop faxing 4
To stop faxing, press Stop/Exit.
Setting scanner glass size for
faxing 4
When documents are Letter size, you need to
set the Scan Size to Letter. If you do not, the
side portion of the faxes will be missing.
a Load your document.
b Press (FAX).
c Press a or b to choose
Advanced Settings.
Press OK.
d Press a or b to choose
Glass ScanSize.
Press OK.
e Press a or b to choose A4 or Letter.
Press OK, and then press Clear.
f Enter the fax number.
g Press Mono Start or Colour Start.
NOTE
• You can save the setting you use most
often by setting it as the default setting.
(See Advanced User’s Guide: Setting
your changes as a new default.)
• This setting is only available for sending
documents from the scanner glass.
Colour fax transmission 4
Your machine can send a colour fax to
machines that support this feature.
Colour faxes cannot be stored in the
machine’s memory. When you send a colour
fax, the machine will send it in real time (even
if Real Time TX is set to Off).