Chapter 5
32
Dual Access
(Monochrome only) 5
You can dial a number and start scanning the
fax into memory—even when the machine is
sending from memory, receiving faxes or
printing PC data. The LCD shows the new job
number and available memory.
The number of pages you can scan into the
memory will vary depending on the data that
is printed on them.
Note
If the Out of Memory message
appears, press Stop/Exit to cancel or
Mono Start to send the pages scanned so
far.
Real Time Transmission 5
When you are sending a fax, the machine will
scan the documents into the memory before
sending. Then, as soon as the telephone line
is free, the machine will start dialling and
sending.
Sometimes, you may want to send an
important document immediately, without
waiting for memory transmission. You can set
Real Time TX to On for all documents or
Next Fax Only for the next fax only.
Note
• In Real Time Transmission, the automatic
redial feature does not work when using
the scanner glass.
• If the memory is full, faxes from the
scanner glass cannot be sent until you
clear some of the memory.
• (MFC-295CN)
If the memory is full and you are sending a
black and white fax from the ADF, the
machine will send the document in real
time (even if Real Time TX is set to
Off).
Sending in real time for all faxes 5
a Make sure you are in Fax mode .
b Press Menu, 2, 2, 3.
3.Real Time TX
Realtime TX:On
c Press a or b to choose On (or Off).
Press OK.
Sending in real time for the next fax
only
5
a Make sure you are in Fax mode .
b Press Menu, 2, 2, 3.
c Press a or b to choose
Next Fax Only. Press OK.
d Press a or b to choose Next Fax:Off
or Next Fax:On.
e Press OK.
Note
In real time transmission, the automatic
redial feature does not work when using
the scanner glass.
To Next Page
Loading...
Need help?
General
