6-4
Messages on the LCD Probable Cause
SCANNER ERROR In the scanning compensation data list printed by the
maintenance-mode function code 05, fifty percent or more of
the white level data is faulty.
(This message may appear only in the maintenance mode.)
TONER EMPTY
Open cover, then replace
new toner cartridge.
The toner sensor has detected that there is no toner in the
cartridge or that no toner cartridge is loaded. If this message
appears, recording is no longer possible.
TONER LOW The toner sensor has detected that there is not enough toner.
WARMING UP
WAIT FOR A WHILE
The in-casing temperature is too low. If the temperature reaches
the appropriate level, the machine will be automatically
recovered from the error state.
If only an alarm beep is heard without any message on the LCD when the machine is turned on, the
ROM or RAM will be defective.
To Next Page
Loading...
