4-33
4.1.10 Scanner Mount
(1) Remove the harness cover.
NOTE: Once removed, the harness cover will become unusable and a new part will have to
be put back in.
(2) Remove the relay (ADF) harness from seven latches and then bring it to the right.
(3) Remove the two screws from the scanner mount
(4) Remove the scanner mount in the direction of the arrows.
n Reassembling Notes
• Route the relay (ADF) harness through seven latches on the scanner mount. Refer to Subsection
4.1.25, "Harness routing C."
To Next Page
Loading...
