Brother MFC6800 - Page 157

EEPROM CUSTOMIZING CODES
This function allows you to customize the EEPROM according to language, function settings, and
firmware switch settings.
 Operating Procedure
(1) For machines w/ fax
To make the machine enter the maintenance mode, press the Menu, *, 2, 8, 6, and 4 keys in
this order.
For machines w/o fax
To make the machine enter the maintenance mode, press the Menu, 0, 2, 8, 6, and 4 keys in
this order.
The machine beeps for approx. one second and displays "
" on the
LCD.
(2) Press the 7 and 4 keys in this order in the initial stage of the maintenance mode.
The current customizing code (e.g., 9001 in the case of MFC6800 U.S.A. version) appears.
(3) Enter the desired customizing code (e.g., 0002 in the case of MFC6800 Canadian version).
The newly entered code appears.
NOTE: If a wrong 4-digit code is entered, the machine will malfunction.
(4) For machines w/ fax Press the Fax Start key.
For machines w/o fax Press the Sort key.
The machine saves the setting and returns to the initial stage of the maintenance mode.
If you press the Stop key or no keys are pressed for one minute in the above procedure, the
machine stops the procedure and returns to the initial stage of the maintenance mode.
Within 2 seconds
Within 2 seconds