Brother MFC6800 - WSW21 TAD Setting 1; WSW22 ECM Setting

25
WSW21
(TAD setting 1)
Selector
No.
Function Setting and Specifications
1
|
7
Not used.
8
Erasure of message stored in the
memory after the message transfer
0: Yes 1: No


 Selector 8: Erasure of message
Setting this selector to "0" will erase the message recorded in the memory after the document
retrieval feature transfers the message.
WSW22 (ECM setting)
Selector
No.
Function Setting and Specifications
1 ECM* in sending 0: ON 1: OFF
2 ECM* in receiving 0: ON 1: OFF
3 Call Waiting Caller ID 0: ON 1: OFF
4 Not used.
5
|
8
Acceptable TCF bit error rate (%)
(Only at 4800 bps)
0: 0% 1: 8%
0: 0% 1: 4%
0: 0% 1: 2%
0: 0% 1: 1%
* ECM: Error correction mode
NOTE: Selector 3 is applicable to the American version only, but not applicable to those models
equipped with high-speed modem.
NOTE: Selectors 5 through 8 are applicable to the Asian version only.


 Selector 3: Call Waiting Caller ID
Setting this selector to "0" allows the user to decide whether or not to interrupt the current call
when a new call comes in. If Call Waiting Caller ID service is available in the area and the user
subscribes to it, he/she can see information about his/her incoming call.


 Selectors 5 through 8: Acceptable TCF bit error rate (%)
Setting two or more selectors to "1" produces addition of percent assigned to each selector. If you
set selectors 7 and 8 to "1," the acceptable TCF bit error rate will be 3%.