33
WSW31
(Function setting 9)
Selector
No.
Function Setting and Specifications
1 Not used.
2
Default reduction rate for failure of
automatic reduction during recording
0: 100% 1: Reduction rate s
to the current
paper size
3
4
Not used.
5
Minimum short-OFF duration in
distinctive ringing
0: 130 ms 1: 90 ms
6
7
Not used.
8
"CHANGE DRUM SOON"
message
0: Yes 1: No
Selector 2: Default reduction rate for failure of automatic reduction during recording
This selector sets the default reduction rate to be applied if the automatic reduction function fails
to record one-page data sent from the calling station in a single page of the current recording
paper.
If it is set to "0," the machine records one-page data at full size (100%) without reduction; if it is
set to "1," the machine records it at the size specified according to the current paper size.
Selector 5: Minimum short-OFF duration in distinctive ringing
The ringer pattern consists of short and long rings, e.g., short-short-long rings. This selector sets
the minimum OFF duration following a short ring in order to avoid missing ringer tones in
distinctive ringing.
If this selector is set to "1," when the short-OFF duration is a minimum of 90 ms long, then the
machine will interpret the short-OFF as OFF.
Selector 8: "CHANGE DRUM SOON" message
This selector determines whether or not the "CHANGE DRUM SOON" message should appear on
the LCD when the service life of the laser-sensitive drum in the laser unit will expire soon.
To Next Page
Loading...
