4-20
(5) While keeping the scanner unit open (in the direction of arrow ), disconnect the CCD flat
cable (arrow
) from the relay PCB.
NOTE: Handle the CCD flat cable with care.
(6) Open the scanner unit further and lift up its rear edge to disengage it from the scanner mount.
Then shift the scanner unit to the front right as shown below (arrow
) so that the relay PCB
can be fully seen.
CAUTION: When putting the scanner unit on the scanner mount, take special care not to
bend, wrinkle, or scratch the CCD flat cable or not to break the boss of the front cover (that is
provided for the scanner open sensor actuator) by the bottom of the scanner unit.
To Next Page
Loading...
