Brother MFC6800 - Page 81

4-47-1
n Reassembling Notes
• Be sure to route the heater harness through U-shaped cutout "e" provided in the power supply
shield. Then, route the AC power cable through the same cutout "e" on the heater harness.
(Refer to Subsection 4.1.25, "Harness routing H."
• Fit the front tabs of the low-voltage power supply PCB into openings "f."
• Fit the front tab of the insulator sheet into opening "g."
• To prevent the blue and brown lead wires of the AC power cord from getting damaged by the
edge of the power inlet support or the end of screw "c," be sure to observe the following routing
instructions:
For the power inlet support having no opening
1) Route the grounding wire between the boss and the power supply shield as shown below.
2) Push down the ferrite cores of the AC lead wires and grounding wire.
3) Secure the grounding terminal to the power inlet support with screw "c" at an angle shown
below.
Power
supply
shield
Boss
Route the grounding
wire between the boss
and the power supply
shield.
Push down these ferrite cores.
Secure the grounding
terminal at this angle.
(Rear)
Screw "c"