4-53
(5) To take off the paper feed solenoid, solenoid lever, or clutch release lever, remove the two
screws.
n Reassembling Notes
• If the friction spring in the gear drive unit slips off, fit the straight end of the spring in the
support hole of the gear drive unit as illustrated above.
• When putting the gear drive unit back into the main cover, route the solenoid harness and main
motor harness along the outside of the gear drive unit. Be sure to sandwich the grounding plate
between the contact plate and gear drive unit. See the illustration given on the previous page.
• After securing the gear drive unit, route the heater harness through the cable guides provided on
the top of the gear drive unit.
To Next Page
Loading...
