Brother MFC6800 - Page 96

4-60-1
Harness routing H: Harnesses viewed from the bottom of the machine
Power inlet support
(See the figures given below.)
(Power supply shield)
Low-voltage power harness
Cover/registration sensor & fan harness
(Cover/registration sensor PCB)
(Fan)
Fan harness
(Main cover placed upside down)
High-voltage power flat cable
EL harness
Heater harness
(Gear drive unit)
Cable guides
Cable guide
Latch
(Speaker)
Speaker harness
Solenoid harness
Main motor harness
AC power cable
Grounding wire
(which should route
on the heater harness)
(which should be supported by
the looped grounding wire)
For the power inlet support having no opening For the power inlet support having an opening
2 mm max.
1 mm max.
Pull the AC lead wires
in this direction.
Fasten the AC lead wires
with a binder.
Power inlet support
For the harness routing around the power inlet
support, see page 4-47-2.