To Next PageTo Next Page
Need help?Do you have a question about the Bryant Evolution Connex SYSTXBBECC01- and is the answer not in the manual?
General| Category | Controller |
|---|---|
| Model | SYSTXBBECC01- |
| Brand | Bryant |
| Control Type | Touchscreen |
| Humidity Control | Yes |
| Dehumidification | Yes |
| Connectivity | Wi-Fi |
| Alerts | Yes |
| Energy Monitoring | Yes |
| Energy Management | Yes |
| Geofencing | Yes |
| Compatibility | Evolution System |
| Display | Color |
| Remote Access | Yes |
| Power Source | 24V |
| Voice Control | Yes |
| Zoning | Yes |
Manually set or synchronize time and date using the menu options.
Set hour, minute, month, day, or year using up/down buttons and save.
Select the time zone for the location from the menu options.
Enable time synchronization for Wi-Fi capable controls after setting time zone.
Covers installation of Connex Control and Wireless Access Point; setup, commissioning overview.
Inspect equipment for damage or completeness before installation.
Guidelines for placing the Wall Control and Remote Room Sensors.
General guidelines for thermostat wire selection and usage.
General instructions for mounting the Evolution Connex Control.
Connecting bypass and fan powered humidifiers.
Control searches for and identifies the indoor unit during commissioning.
Control searches for and identifies the outdoor unit during commissioning.
Select the indoor evaporator coil for correct refrigerant charge calculation.
Select the appropriate electric heater size if not self-identifying.
Supports hot water coil applications with fan coil or as sole heat source.
Checks for System Access Module for home automation.
Determines if zones are present and identifies sensors associated with them.
Select the air filter type installed with the Evolution System.
Select whether a humidifier is installed in the system.
Select whether ultraviolet lights are installed in the system.
Displays a summary of all automatically found or manually selected equipment.
Checks system airflow and displays static pressure or target airflow CFM.
Measures ductwork size and airflow for zoned systems.
Shows installed indoor/outdoor unit types, filter, accessories, and zone count.
Perform start-up process to learn all equipment in the system.
Accesses configuration menus for various system components.
Perform checkout tests to ensure proper operation of installed equipment.
View installed equipment information and diagnostic tools.
Enter lineset length, vapor line diameter, and verify charge.
Assist in isolating refrigerant into the outdoor unit using pump down procedure.
Open EXV for evacuation or refrigerant recovery.
Set the EXV position and monitor suction pressure.
Establish Wi-Fi connectivity using the homeowner's router.
