Bryant Evolution Connex SYSTXBBECC01- - Page 21

12
ELECTRICAL OPERATION HAZARD
Failure to follow this warning could result in personal injury
or death.
Before installing, modifying, or servicing system, the main
electrical disconnect switch must be in the OFF position. There
may be more than 1 disconnect switch. Lock out and tag
switch with a suitable warning label.
!
WARNING
S Turn off all power to equipment.
S If an existing Evolution Control or other control is being replaced:
d Remove existing control from wall.
d Disconnect wires from existing control.
d Discard or recycle old control.
S NOTE: Mercury is a hazardous waste, if existin g control contains any mercury,
it MUST be disposed of properly. The Evolution Connex Control does not
contain mercury.
S Select the appropriate Evolution Connex Control mounting configuration. Use
the standard backplate provided with the wall control, or add the decorative
backplate in addition to the standard backplate if desired. See Section 4.5 for
more detail.
S Route wires through large hole in mounting plastic. Level rear plastic against
wall (for aesthetic value only; the Evolution Connex Control need not be level
to operate properly) and mark wall through two mounting holes.