7 – 20 Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D © BT
Troubleshooting
Error codes
T code Valid from serial no. Date Order no.
841×842×843 6061850- 2012-08-30 258946-120
Option.
8.001
Safety speed, raising and lowering the
forks not working.
The collision sensor has registered
collision levels that are above the
stated limits.
• Drive carefully.
• Check the value limits for detection
of collision (service parameters 105
and 106).
8.002
Safety speed, raising and lowering the
forks not working.
The truck has intentionally been
disabled by TLS.
Reset the truck to normal operation.
8.003
No event. Truck can be operated as usual. Argument warning from Spider
expansion unit.
Check settings of option parameters.
8.010
No event. Truck can be operated as usual. CAN communication problem with the
battery charger at start-up.
• Inspect the connections and wiring
harness.
• Make sure that ICH [A5] and BCU
[A30] have compatible software.
See
section "7.1 General".
8.011
No event. Truck can be operated as usual. The logic card in the tiller arm handle is
not receiving CAN data from the
battery charger.
Inspect the connections and wiring
harness.
8.014
No event. Truck can be operated as usual. The logic card in the tiller arm handle
cannot send CAN data to the battery
charger.
Inspect the connections and wiring
harness.
8.020
No event. Truck can be operated as usual. The battery charger is not connected to
the battery.
Inspect the connections and wiring
harness.
8.021
No event. Truck can be operated as usual. The battery charger has detected low
battery voltage.
Check battery status.
Code Event Possible cause
Action
https://www.besttruckmanuals.com/
To Next Page
Loading...
