Electric drive motor 1700
Disassemble the motor from the truck
© BT Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D 9 – 3
Order no.. Date Valid from serial no. T code
258946-120 2012-08-30 6061850- 841×842×843
5. Remove the speed sensor's cable connector B11.
6. Remove the temperature sensor B1
7. Remove the motor cables and unscrew the retaining screws of the
motor.
8. Lift the motor out of the truck.
9. If needed, remove the brake and the speed sensor.
Note:
Cover the drive gear to prevent loose items from falling into the drive
gear after the drive motor has been removed.
Install the motor in the reverse order.
See section "9.3 Tightening torques – Drive motor".
Note:
When installing the motor, it is very important that the motor is
aligned so that the grooves in the motor and the motor bracket are
exactly opposite each other before the mounting screws are fitted.
See illustration below.
Tighten the 4 drive motor mounting screws (a). The screws are
tightened cross-wise in two stages. In other words, do not tighten too
much the first time.
See section "9.3 Tightening torques – Drive
motor".
https://www.besttruckmanuals.com/
To Next Page
Loading...
