Troubleshooting
Error codes
© BT Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D 7 – 21
Order no.. Date Valid from serial no. T code
258946-120 2012-08-30 6061850- 841×842×843
8.022
No event. Truck can be operated as usual. The battery charger has detected high
battery voltage.
Check battery status.
8.023
No event. Truck can be operated as usual. The battery charger has detected low
charging temperature.
Charge the battery at normal
temperature.
8.024
No event. Truck can be operated as usual. The battery charger has detected high
charging temperature.
Check:
• for dirt in the battery charger. Clean if
necessary.
• that the fan is operating.
8.027
No event. Truck can be operated as usual. Serious error in the battery charger.
Replace the battery charger.
8.028
No event. Truck can be operated as usual. The battery charger has exceeded the
time limit for charging.
Check the battery.
8.029
No event. Truck can be operated as usual. The battery charger is charging more
than maximum capacity.
Check:
• battery
• service parameter 110.
8.030
No event. Truck can be operated as usual. Battery charger is installed in truck, but
has not been activated via factory
parameter 1101.
Check factory parameter 1101.
8.031
No event. Truck can be operated as usual. Incorrect setting of battery charger
parameter.
Restart the truck. Check that the truck
and battery charger use the correct
software.
8.032
No event. Truck can be operated as usual. If the error code is shown when
charging with a built-in charger,
parameter 109 is set wrongly.
Check service parameter 109.
Code Event Possible cause
Action
https://www.besttruckmanuals.com/
To Next Page
Loading...
