Operation
WINDINGFEEDER - 3-7 -
Within the P3 level the following parameters can be programmed:
OFFSET AUTO
MOTOR CALIBRATION
ACCESS CODE
DEVICE IDENTIFICATION CODE
Within the P4 level the following parameter can be programmed:
MOTOR ROTATION DIRECTION
SENSOR TYPE
BAUDRATE
APPLICATION (REWIND 1/2 – WARP 1/2)
YARN TYPE (ALL YARN OR ELASTIC)
LANGUAGE SELECTION
USE OF INTELLIGENT TENSION CONTROL ACCESSORY
Press the
(Control) button to switch from one programming level to the next one.
Press
(Reset) button to quit the programming environment.
To Next Page
Loading...
