btsr WINDINGFEEDER - Ordinary Maintenance; Repairs

WINDINGFEEDER Troubleshooting and Maintenance
- 4.4 - WINDINGFEEDER
Anomalie Cause Rimedi
ASC1010 EEP-ERROR
displayed on
WINDINGFEEDER
display
1) Loss of calibration data 1) Reset the alarm; if the problem persists, contact
your BTSR reseller.
WATCHDOG
displayed on
WINDINGFEEDER
display
1) Device internal error 1) Reset the alarm; if the problem persists, contact
your BTSR reseller.
Even if the torque of motor driving the roller rotation is very low and does not involve
hazards for the operator safety, it’s always advisable to lock the motor prior to operate on
the devices (yarn threading, tilt adjustment of coil separation element, etc.) in order to
avoid unexpected motor startup events.
To lock the motor, just press the button on the WINDINGFEEDER device and check
the lighting of buttons’ red LEDs and of TS44 sensor. At the end of the operation, press
again the button and make sure that all the red LEDs turn off.
 If the fault is not included in the above table, please contact your local BTSR reseller, giving a
detailed description of the kind of fault and the conditions in which it occurred. Should be necessary
to call the BTSR Technical Service Department, read the code printed on the faulty device, as this
information could be useful to BTSR technicians.
Example:
Device code: WINDINGFEEDER
……………………
Ordinary Maintenance
The WINDINGFEEDER devices do not require special maintenance interventions,
except a periodical cleaning, depending on the environment condition in which they
operate.
For cleaning purposes, do not use solvent, but rather a soft cloth
dampened with neutral detergent or alcohol.
Repairs
Any repair intervention on WINDINGFEEDER devices must be carried
out by specialized BTSR technicians.
Any intervention attempt by non authorized personnel, voids the
warranty terms.