BTX Gemini X2 - Using an HT Plate Handler; Using Specialty Electrodes; Using Specialty Protocols

Gemini Series Electroporator User’s Manual
toll free 800.272.2775 • 508.893.8999 • www.btxonline.com
28
Using Specialty Protocols
Using Specialty Electrodes, Gemini X2 Only
Plug the specialty electrodes into the front ports of the
BTX Gemini X2
Scroll through available protocols.
Double tap desired selection.
Scroll through available cells.
Double tap desired cells.
Review parameters.
Position electrodes on area being electroporated.
To run tap the Omega icon.
With load measurement OK, press the Go icon to run protocol.
While the pulse is being delivered, the Square icon can be used to
stop the protocol at any time.
✐
NOTE: Generator will display readings after each pulse.
Using an HT Plate Handler, Gemini X2 only
(continued)
Once protocol is complete, data regarding your pulse is displayed
and stored in the systems logs for future use.
You may continue pulsing, go back to the settings screen or
protocol select screen, or to the home screen.